1. There are three steps to install the software, dongle driver, camera driver, and test main program
2. Calibration Adjust the magnification of the lens to,,,, and adjust the correction coefficient on the software to one Corresponding (the magnification factor does not need to be corrected, it is only used for scanning thumbnails). , Plane correction adjusts the grid to the clearest, click menu system/plane correction, it is required to find the lines of the grid correctly (less display is OK, if messy lines are displayed, the focus is unclear), and then correct it to, For thickness correction, adjust the correction block to the clearest position. Move the lower plane to the far left. Adjust the red laser line and the cross line on the reference plane to coincide with each other. Click Add. After scanning, select the line just added in the program on the right and click To measure, draw three boxes on the reference surface and one box on the measurement surface, and the thickness value will come out. If not, click the menu System/Thickness Calibration, enter to confirm, and the correction is completed.
3. Make a thumbnail, adjust the lens magnification to one level, specify the lower left corner and upper right corner of the board, and then click Capture. Automatic scanning to generate thumbnails.
4. Move the point to the center of the point, turn on the laser, adjust the laser line of the low plane to coincide with the cross, or click to focus again, select the reference point in the upper right corner of the software and set it in Draw a small frame in the window to cover the white part of the dot. The second point is done in the same way.
5. Add a test point and move it to the point to be measured. The leftmost side of the laser line in the window must be the reference plane, not any other uneven position. , add, automatically scan, select this line, point measurement, draw three boxes on the reference surface, draw a box on the solder paste, the thickness will be measured, and then click record (the symbol is a check mark), you can measure this point Rename and set thickness upper and lower specification lines and other parameters. , then add more points and repeat the above steps. 6. For normal testing, call up the program to be tested, put the board in the innermost position (press it with a positioning block to prevent deformation), press the start button on the machine, fully automatic testing, and automatically record the data of each test. After testing, take out the board and test with another board.
Click for related knowledge (
Introduction to solder paste thickness gauge
)
News